Skip to main content

35 Messages

 • 

570 Points

Wed, Nov 20, 2013 3:22 AM

Answered

Dual 7731 in Link Agg mode

7731 Outdoor AP's in bridge mode. Is it possible to add a 2nd Pair and setup Link Agg/Trunking so we have 2 AP's on both roofs, to double the bandwidth?
Or will tis create a loop?

Responses

368 Messages

 • 

5.6K Points

7 years ago

I'd say yes, but you'll need more than just 2 pair of 7731s. You'll also require a switch on both sides of the link to handle load-balancing and/or aggregation.

2 Messages

 • 

90 Points

7 years ago

This is correct. Link aggregation is handled by intelligent switches (see LACP). In this sense, a pair of 7731 is just one link between two switches.

I would be more concerned about interference between the two pairs. Even when you choose lowest and highest channels. Does anybody have experience with such a configurartion? How far apart should the 7731s be at either end? 50cm, 1m, 5m?

368 Messages

 • 

5.6K Points

7 years ago

At minimum I would put them 1m apart and at least 1 channel empty in between.

35 Messages

 • 

570 Points

7 years ago

Thanks for the info, but i changed my design, so i don't need this setup.

6 Messages

 • 

120 Points

6 years ago

I tried. One pair will in disable mode but failover is working if the active link is down. I test with peer to peer bandwidth test but the result showed the bandwidth not double up.

1 Message

 • 

60 Points

6 years ago

This is not surprising. The load balancing is done for end to end pairs, typically based on MAC addresses. When you measure between two machines, only one link will be used. Measure between a different pair of machines at the same time and you should see both getting the full bandwith of one link.

If you want to double the bandwith for a single communication pair, it gets much more complicated. You would need high speed routers on both ends to do packet based load balancing.