Disable 2.4 on single SSID

I've got something wrong as it seems like I'm just disabling all 2.4GHz with my attempt. I have to start over, something is off with my logic on this.

so I have two SSID groups, each with an SSID called "Find Me", which I've added to each of the WLAN Groups below.


Now on my test AP, "BwayNoc AP1" I've got my fresh AP groups selected.




And here is how I have the adjacent (AP 4,) AP programmed.



assuming of course that AP4 would fall too close to AP1, and need its radio turned completely off.


I may be missing the point though, so don't hesitate to call me out if I'm not "getting it".

Thanks

-Andrew

I need to screenshot everything and reply back, but basically what I had was close, but doing the opposite of what I wanted. Circling back to the thread when I've got some breathing room. :)

Kind of a mess because I have other groupings going on here, but in the WLAN config, I have two groups of interest, the "Default" group and the "Fuze no 2.4" group. "Fuze" is the SSID where I do not want 2.4 enabled. "Default" includes the SSID where I want 2.4 disabled, and "Fuze no 2.4" does not include the Fuze SSID:





There's not much to set in these groups, just really a list of WLANs.

In the "APs" section, that's where we do things and since I already have a general "no 2.4GHz at all" group which has some APs in it to avoid overlap and such, these two groups are the only real configs of interest here:





Every AP (ignore my "guest group") is in either in the "disable 2.4GHz" group, so it wasn't enabled for the Fuze SSID in the first place, and the "Fuze Disable 2.4GHz" group contains the rest of the APs. In the config for the "Fuze Disable 2.4GHz" AP group, I have the "Fuze no 2.4" WLAN group selected, so those APs only have the SSIDs in the "Fuze no 2.4" group enabled.



Make sense? It's kind of backwards. This whole system is kind of a pain and not very intuitive.