D

6 Messages

 • 

130 Points

Fri, Nov 19, 2021 10:21 AM

200.11.10.5.195 Broken AD Login?

I recently upgrade to the lastest 200.11.10.5.195, once the AP rebooted I suddenly could no longer login. The login screen would take the username and password, turn it to starts, and then just sit there and flicker. I had to factory reset to get back into the AP. SSH also would just timeout trying to login. Then I tried to re-setup AD login, and it would do the exact same thing. Then after ssh-ing in with local credentials I went to debug mode, and when I run "logs winbind 1" I get the following.

killall: winbindd: no process killed
sh: winbindd: not found

Was winbindd not put into this image?

6 Messages

 • 

130 Points

10 d ago

I rolled back to 200.10.10.5.253, and everything worked right away.

Employee

 • 

12 Messages

 • 

180 Points

10 d ago

Hi Dan,

Thanks for reaching out to Ruckus. We might need to replicate the same in lab to find out the root cause, because it's perfectly fine on 200.10.x version.

The command you mentioned "logs winbind 1",  is it  a shell command? I haven't found this in our Unleashed CLI Guide for any version.

(edited)

6 Messages

 • 

130 Points

@Ratnadeep

I went into enable mode, then debug, then ran "logs winbind 1". But I think this may be a red herring because I just tried it on 200.10 and it gave me the same results with AD login working.

Official Rep

 • 

1.3K Messages

 • 

17.7K Points

Hi Dan,

If its a Linux command, it will not work because you are in Ruckus CLI, which is running on top of Linux.

I suggest you to open a case with support and we can look into the issue.

@Ratnadeep check once if you are able to reproduce this in lab.

(edited)

Regards,

Syamantak Omer

Official Rep | Staff TSE | CWNA | CCNA | RASZA | RICXI

Follow me on Linkedin

Important Announcement