1 Message


70 Points

Sat, Jan 23, 2021 2:09 PM

ICX7250P POE Daughterboard Replacement?


I have obtained a ICX7250P with 08.0.95ba Firmware

The switch works normally, but the POE Module Reports:- Severe Error - Module Failed to Init.

I have reloaded the Boot, Image and POE Firmware with no effect.

The switch works normally, the POE module fails to initialise.

On closer internal inspection this unit has a defective POW Daughterboard, please see the attached picture. The “MSC” IC is burned.


Is it possible to obtain a replacement POE daughterboard?


Is it possible to just remove this daughterboard and use it as a Non-POW switch?


Any insight will be really appreciated.


Thanks in advance.



Official Rep


210 Messages


3.1K Points

1 y ago

Hi Dan,

You can reach out to the support team with serial number of the switch and request an RMA. ICX switches have a limited lifetime warranty. 
Warranty only applies to the original owner of the product, and doesn't cover environmental damage, misuse, and a variety of other exclusions that are explicitly mentioned in the document referenced in support site.

Hope it helps

Important Announcement