N

1 Message

 • 

70 Points

Sun, Jun 6, 2021 4:43 AM

ICX 7150 C12P Switch

Hi everyone,

I got a house (Lennar) and it comes with ICX 7150 C12P and I tried adding the ethernet cables to the switch so I could connect tv's and computers in different rooms to ethernet. But I'm getting 10 Mbps. How do i change the port to have actual speed to 1G-Full instead of having 10-full. I looked everywhere for an option to change actual speed/mode but I don't see it. Can someone please advise? I want to have ports 1/1/1 through 1/1/12 at 1G -Full. 

If I change configure speed/mode to  1G-full-master or 1G-full-slave speed duplex the port is not available it shows down. 

Employee

 • 

187 Messages

 • 

3.2K Points

6 m ago

Hey There, 

It could be a bad patch/termination or cable. Have you tried a different cable run or cable itself? You should not need to set the speed manually. If it negotiates down to 10Mb it is generally due to layer one issues (cable, patching, etc.). 

Important Announcement