J

3 Messages

 • 

90 Points

Sun, Aug 22, 2021 8:26 PM

7150 no POE to APs

Why is my switch not powering the access points?

12 Messages

 • 

314 Points

2 m ago

If you run image older 080.80 you need to use this command

interface eth 1/1/x

inline power 

Otherwise please type show inline power and show as the result

3 Messages

 • 

90 Points

2 m ago

What if the switch won’t transmit its own WiFi to be able to access the software settings?

12 Messages

 • 

314 Points

@john_taylor

I think you mean you can not access the AP  like ping or HTTP; so you need to be sure your pc and AP are in the same VLAN and your pc have the same range of networks like ( the pc IP 192.168.1.10/24 and the AP IP 192.168.1.11/24 so you can access the AP in the switch Succesful.

Official Rep

 • 

136 Messages

 • 

4.1K Points

2 m ago

Hi John

You need to enable poe on the interfaces like Mohammad mentioned.

Hope this helps

Thanks

Hashim

3 Messages

 • 

90 Points

2 m ago

All; The AP needs power to emit the Configure.Me-xxxxxx to enable access.  How can I power the AP if the switch does not do it?  How can I access the switch to tell it to power the AP if not via Configure.Me-xxxxxx?

Official Rep

 • 

136 Messages

 • 

4.1K Points

@john_taylor 

Hi John

If you go to interface context in enable mode and run command:

inline power, it will enable the poe on the port and provide power to the AP.

Thanks

Hashim

Important Announcement