Skip to main content

66 Messages

 • 

1.2K Points

Fri, Sep 6, 2019 10:19 PM

ZF7982 trunk configuration failing

Hello, I have joined a ZF7982 AP to Smartzone running 3.2 firmware. It was working fine, until SmartZone prompted me to install an updated Ruckus certificate.
My initial port configuration had been LAN1 = trunk, LAN2 = access.  The AP was connected to my switch via the trunk.
As soon as I deployed the certificate, I lost connection to the AP. 
To restore connectivity I had to re-configure my switchport from trunk to access.
Has anyone seen this sort of problem before ?

Responses

No Responses!