Official

Accepted

Unanswered

Advanced Filters

Search Results (73)

Relevance

Accepted Solution

Official Solution

Descent Priced Smart Zone Controller

Hello, I am wanting to get around 8 access points and they need to be FIPS compliant. From what I've gathered I would need a SmartZone controller to run them in FIPS mode. Some of the controllers look like way more than what I need. I was just curious if there's a controller you guys would recomm

Question

 • Access Points

34

4

0

Accepted Solution

Unleashed Firmware Upgrade option frozen (200.7.10.202.94)

Hi, I'm trying to update the firmware on my unleashed network, however when i go to the upgrade page the screen just hangs as per image below. the button is non-responsive.  All the devices are on the same firmware version (200.7.10.202.94).  I've tried shutting all the devices down at th

Question

 • Access Points

73

3

0

Accepted Solution

iPhone name not show on admin portal after upgrade to 200.10.10.5.246.

After upgrade R320 Unleashed software version to 200.10.10.5.246, find that user's iphone name not show admin portal. All show Mac Address only. Is it normal or how to fix this?

Question

 • Unleashed

29

2

0

Accepted Solution

SmartZone 100 (SZ104) - Discovering Multiple APs

Planning to deploy 100+ APs in to a SZ cluster (2x SZ104). What's the best way to enable AP discovery by the WLC? WLC IP is in 172.x.x.x/24 range (MGT). Do the APs have to be in the same range as the WLC to be discovered? If so, how can we enable 172.x.x.x range in all the APs? (Is the only optio

Question

 • SmartZone (SZ) & Virtual SmartZone (vSZ)

49

3

0

Official Solution

Streaming to two IPTVs via ETH from a H510

Good day all, I am trying to find a solution for a site requiring IPTV with too few data points. Is it possible to stream to two IPTVs via the ETH ports on a H510? I am not sure if the AP will be able to handle the load. Regards Migael

Question

 • Access Points

26

2

0

Accepted Solution

Is there a way to verify how much wattage an AP is receiving?

I have an R550 with the current firmware on it.  It has an orange Icon in the corner of the unit about the  wifi 6 indicator.   When I click onit I get - "Not enough electricity is provided to this AP, it's capabilities are degraded.  Please refer to "unleash power supply c

Question

 • Access Points

30

3

0

Accepted Solution

ICX 7150 c12p - AP with multiple VLANs

Hi, I've not been able to find an answer for this. I have multiple VLANs on being tagged by my Access Point (R610 for now, will get more later): default (50) default-iot(200) The AP is connected to an 7150 (PoE), and when I try to tag multiple VLANs to the same port I'm told that is not po

Question

 • Switches

24

2

test

testhttps://docs.ruckuswireless.com/unleashed/200.1.9.12/#c-RadioBGN.htmltest

Question

 • Flexmaster

17

1

0

Ruckus Technical Family

Selam arkadaşlar, 29 Eylül Çarşamba günü yapacağımız SZ ile Sorun giderme eğitimini tekrar hatırlatmak istedim. Aşağıdaki linkten kayıt yapabilirsiniz. https://commscope.webex.com/commscope/j.php?RGID=r175463fa61947628c9443497e4a3c80c Nabi

Question

 • Turkey – Türkçe

8

0

Do the R510's support antenna's - need external antennas

Hello, I have a warehouse with about 30 R510's.  I need to put two APs in heating boxes designed for APs - they get power from POE to keep the units warm.   My guy has used Aruba's in the past that support antennas which attach to the units and stick out of the heating boxes. 

Question

 • Access Points

26

2

0

R510 Unleashed disconnected from Internet

I have an R510 with Unleashed version 200.10.10.5.246 connected to a Vigor 2960 router via a PoE-switch.Router and R510 are on the same subnet and same VLAN.The Wifi clients are connected to the Internet, they get their IP address from the DHCP server on the router (= gateway), so no issues there.Bu

Question

 • Unleashed

30

2

0

New Lennar Home and Slow Internet Speeds

I purchased a new Lennar townhome in Spring 2021. It has 4xR510 WAPs all connected to a ICX7150 switch running over Cat6e. We have Verizon Fios 1gb service. When i perform a Verizon speed test it says the the download speed is ~950mbps to the router and if i connect directly to the Verizon router wi

Question

 • RUCKUS at Home

66

1

Hardware solution for Dual WAN gateway to gateway VPN

Hello, I am looking to connect 2 geographically distant (> 5 miles) sites. Both sites have dual WAN fail over, and dynamic IP's from each ISP. I am looking for a hardware (or general solution) recommendation to allow a secure connection between both sites that could withstand a WAN fail ov

Question

 • Switches

30

1

0

Issue Connection 2.4Ghz and 5Ghz can not stable

I have got issue within this below -2.4 dan 5 ghz enable some windows connect successful ( 802.1x authentication)-2.4 Ghz only some windows successful connect ( 802.1x authentication)-5 GHz Only windows can not connect ( 802.1x authentication)-Windows connect 5ghz only using preshared key SSID, can

Question

 • ZoneDirector

19

1

0

九月份RTF网络研讨会回放

研讨会主题:Ruckus Analytics最新功能介绍 回放网址: https://commscope.webex.com/recordingservice/sites/commscope/recording/playback/a502add5fd8010398b2e0050568f529f 密码:GkDhim?4

Question

 • China – 简体中文

17

0

0

Guest pass code login again in another access point

Dear all, I am using the ruckus virtual smart zone controller. All my AP are connecting with this controller and create guest wifi for guest users. I can generate guest pass code and login with single AP. There is no problem. My problem is - When I connect guest wifi with another AP that use s

Question

 • SmartZone (SZ) & Virtual SmartZone (vSZ)

24

1

0

RTF webinar, wrzesień 2021 - nagranie

Tutaj znajdziesz nagranie z webinaru: https://video.commscope.com/watch/Yyr7ViLHyscYAWFT7vvEjd?

Question

 • Poland - polski

8

0

0

Curso específico sobre redes Wifi

Olá, estou em busca de cursos sobre redes Wifi que contenham conteúdo avançado. Alguém recomenda algum curso ou livro?

Question

 • Brazil – Português

17

1

0

SSID not showing when policy is configure on the SmartZone

Upon configuration of the policy, the SSID created was not showing in the end devices. Hoping for your soonest response. Thanks you.

Question

 • SmartZone (SZ) & Virtual SmartZone (vSZ)

16

2

0

ZD 1200 D-PSK based VLAN

Hello all, I'm planning to connect WiFi devices (including IoT) on a same SSID but I need them to be included in a given VLAN depending on used PSK. The goal is to have x defined VLAN on x defined PSK. For exemple, each device connected on SSID using PSK number 12 will be connected in VLAN 12.

Question

 • ZoneDirector

17

4

0