Setting ethernet port mode to bridge in Unleashed (R500)

The R500 has two ethernet ports. It seems however there isn't the level of detail or configuration i'd expect with the physical ports compared to the flexibility of other options in Unleashed.

I checked the command line but the only reference is in the ethernet port status:

ruckus# show ethinfo

System Ethernet Overview:

Port 0:

Interface= eth0

MAC Address= d4:00:00:00:00:00

Physical Link= up

Speed= 1000Mbps

Port 1:

Interface= eth1

MAC Address= d4:00:00:00:00:01

Physical Link= down

Speed= 1000Mbps

What i want to do is be able to bridge the second port in, so another device can connect to the network. So fairly simple. Note i have not connected the device yet. How do i set this?

However as an aside, i would have thought i could also configure the vlan options of each port, whether it is trunk/access mode, etc. Am i missing something?

Thanks.

Responses

abilash_p_r

61 Messages

•

956 Points

4 years ago

Hi eXDeeNZ,

We can have a client connect to second port and use it, it does not need any configuration, unless you want it to get an IP from different vlan.

Regards,
Abilash PR.

james_aragoza

1 Message

•

60 Points

And how can we configure it to a different vlan?

3 years ago

ian_cooke_d6pwryzr8vhc0