Once Mesh is enabled Unleashed does not come back up.
We have 3 T610 AP's. They arrived with 220.127.116.11.235. We upgraded to 18.104.22.168.308, configured Unleashed with 2 SSID's, RADIUS and the whole 9 yards. Enabled Mesh and Unleashed did not come back up. Each of the 3 AP's on their HTTP interface were showing "Building the Unleashed Network. It may take a
few minutes.". Powered off 2 WAP's, got onto the CLI of the other and reset to factory. Downgraded firmware back to 22.214.171.124.235 and enabled Mesh from the wizard - same result. Reset and upgraded to 126.96.36.199.310, first configured Unleashed then enabled Mesh and got stuck in "Building the Unleashed Network. It may take a
few minutes.". Reset again and set Mesh in initial wizard and again it's stuck. Anyone seen this or have any thoughts?
I'll have a couple of R510's in a week or so and will try setting up Mesh on those and then joining the T610's to that Unleashed config and hopefully get Mesh to work that way.