Skip to main content
R

Tue, Dec 1, 2020 12:36 PM

AP phone home

i wanna flash on a few R310 and R610 from standalone (or sz or zd) to unleashed firmware but i still wanna make them phone home so i can still see them,

how can i do this?

Responses

Official Rep

 • 

722 Messages

 • 

11.3K Points

2 months ago

Hi Rasaru,

Could you provide more details about your requirement.

Do you want to manage the network from your phone? That's what I understand.

If yes, you can use Unleashed Mobile App to manage the Unleashed using your phone.

https://www.commscope.com/resources/apps/ruckus-unleashed/

Regards,

Syamantak Omer

2 Messages

 • 

80 Points

no,

i have few r310 and 610 that i can see them connected to my network,

all of my ruckus ap's dont have unleashed firmware,

if i change the firmware to unleshed i still see them¿

Official Rep

 • 

722 Messages

 • 

11.3K Points

Ok, so you have R310 and R610 APs previously configured in standalone mode. Later, you upgraded them to Unleashed and made a single Unleashed network. However, you are still seeing old WLANs which were configured on standalone APs.

How many APs you have? Could you make sure all the APs are part of single Unleashed network after the upgrade and all the APs are showing in Unleashed GUI.

Try to connect to the old WLAN and see if you are able to connect. Also double check if old WLAN and new one configure on Unleashed has different names.

If you are able to connect to old WLAN, this mean there is another AP in the network which is still running in standalone mode or there is another WiFi router using the same SSID name.

Regards,

Syamantak Omer