Skip to main content

90 Messages

 • 

1.6K Points

Sat, Jul 30, 2016 5:57 PM

ACL not working correctly

I'm setting up an ACL for a WLAN to rate limit iOS devices and allow all others by default. When I apply this method, all non-iOS clients disconnect and cannot connect to the WLAN. I'm under the impression that all non-iOS devices should be able to connect to the WLAN without any rate limit restriction. 

Responses

37 Messages

 • 

592 Points

4 years ago

I'm guessing Implicit Deny is in effect like on Cisco ACLs so you must add another rule (next line) for non-iOS devices?

222 Messages

 • 

3.6K Points

4 years ago

What software version are you running on the controller? Have you checked known product issues for you version of software? The setting 'allow all by default' should mean other devices can connect but maybe there is a bug in your load.

Also, what is the reason to rate limit iOS only?

90 Messages

 • 

1.6K Points

4 years ago

That's how it works on a ZD managed network when "allow all by default" is selected. I am on 200.1.9.12.62. There are no known issues related to ACL in the software release notes.

222 Messages

 • 

3.6K Points

4 years ago

Ah so this is a standalone AP?

222 Messages

 • 

3.6K Points

4 years ago

What AP?

90 Messages

 • 

1.6K Points

4 years ago

No, this is an unleashed network. I have another site that uses ZD and the "allow all by default" allows all other clients without limitations. APs are R310.

222 Messages

 • 

3.6K Points

4 years ago

Then i would suggest you log a case with support as its most likely a bug. Sorry :(