Skip to main content

Fri, Aug 5, 2016 2:57 PM

Answered

ZoneFlex Mesh presetting

Hello everyone
There is a need to mount the access point without uplink.
The difficulty is that this access point can't be accepted, provisioned and configured by the controller before installation.
Is it possible to configure the access point not only the ip address of the controller, but the Mesh network to which it is necessary to connect when the power is turned on?

Thank you in advance for your cooperation

Regards,
Pavel

Responses

333 Messages

 • 

5.1K Points

4 years ago

This can be accomplished by doing the following:

Enable mesh:
set mesh auto
For manual mesh provisioning, use meshprov
set meshprov {ssid|passphrase} ""
For Mesh configuration recovery, use meshcfg
set meshcfg {ssid|passphrase} ""
To set IP address
set ipaddr wan 192.168.0.2 255.255.255.0 192.168.0.1
If the network has a VLAN
set ipaddr wan vlan 10 192.168.0.2 255.255.255.0 192.168.0.1
Note: Ensure you set the ethernet interface to trunk or the VLAN will not work
set interface eth1 type vlan-trunk untag none
Good Luck :)
Brand User

Former Employee

 • 

2.6K Messages

 • 

44.8K Points

Find your ZD's Mesh ssid|passphrase info on the Configure/Mesh ZD WebUI page!
https://support.ruckuswireless.com/answers/000001491

15 Messages

 • 

320 Points

Hi Michael,
I faced with a problem that AP T301 with FW:100.0.0.0.127 don't know mesh commands.
And I can't configure it.

Any ideas? 

15 Messages

 • 

320 Points

4 years ago

Thanks guys
This is what we need