lldp-med at P300

I need to transport some few vlans and also lldp-med functionality to the other side of a P300-P300 link. Does that work ? Could not find any guidance for the setup.

Responses

Accepted Solution

syamantak_omer

Official Rep

•

804 Messages

•

12.1K Points

11 days ago

Hi Stavros,

If AP eth port is set to trunk, all VLANs are tagged and VLAN 1 is Native VLAN. So whatever you pass from gateway side switch, will pass to non-root side switch.

LLDP-med is not supported I think but I will check if I can find more information for you.

In the meantime, you can connect two P300s and take a pcap on either sides of P300 network to see if LLDP traffic is passing or not.

Regards,

Syamantak Omer

stavros_karaguloglou

2 Messages

•

130 Points

11 days ago

Thx Omer

This LLDP-MED is absolut must for the use-case.

If I had a couple of P300's available, I'd done the test. But, I do not.

So I am in search of a reliable source who can guide me on this.

stavros_karaguloglou

lldp-med at P300

Responses

syamantak_omer

stavros_karaguloglou

Was this helpful?