Skip to main content
J

Wed, Feb 24, 2021 9:16 PM

LAG Configuration for P300 bridges

Looking to set up a configuration with two P300 root bridges connected to an icx7150 and two P300 non root bridges connected to an icx 7250 and utilizing link aggregation to provide more bandwidth. I found this reference on the ruckus site https://unleashedsupport.ruckuswireless.com/answers/000006437
but at this point with all configuration in place, ports are in an up/LACP-Blocked
From what I have read this can be due to a protocol mismatch, but have not have found any configuration inconsistencies. The ports are tagged for multiple VLANS.  Any suggestions on why this isn't working as expected?

Responses

326 Messages

 • 

4.4K Points

2 m ago

Does link work if you disconnect one bridge from the switch?

Official Rep

 • 

326 Messages

 • 

5.1K Points

Yes I would start with one pair first and then extend.

regards

Martin

326 Messages

 • 

4.4K Points

2 m ago

Probably some of mentioned features isn't properly disabled. Anyway, you can create static LAG too, which should work in any case.

(edited)