Skip to main content

5 Messages

 • 

120 Points

Wed, May 21, 2014 5:13 PM

Zone Director 3000

Several need to connect to my AP ZoneDirector 3000 but are in different locations.
As I do.

Responses

683 Messages

 • 

11K Points

7 years ago

Hi Manuel,

I don't understand your question. Can you clarify? Do you have remote Access Points that need to connect to a centralized ZoneDirector? Or users at remote sites that need to connect to the administrative interface of the ZoneDirector?

regards,

5 Messages

 • 

120 Points

7 years ago

Access Points that I need you or centralizen administered by the Zone Manager.

That are located in different cities.

5 Messages

 • 

120 Points

7 years ago

my question is that I have some APs are in different locations and I want to connect them to a ZoneDirector that is located in a different locations from the APs, How can I connect them together??? Imagine that are some APs in different subnets that I want to connect to a ZD that are in a different subnet as well.

824 Messages

 • 

13.2K Points

7 years ago

Hi Manuel,

My understanding is THAT you have "one" ZD in a central location and got AP's in different location. You want the AP's to be managed by ZD in central location.

If above is what you are looking at then i must state that it is a common deployment scenario and very easy to do.

How we do it:

run the command in AP CLI - set director ip (x.x.x.x) where x.x.x.x is the Ip address of the Zone Director and after applying this command, reboot the AP.

Above command is used by AP when it needs to cross L3 boundaries, as long there is a route between ZD and AP. this should work.

Please make sure on both sides router/firewall you have LWAPP port numbers 12222 and 12223 open.

Refer to below doc for more on this from PDF page 23 - https://support.ruckuswireless.com/do...

5 Messages

 • 

120 Points

7 years ago

Thanks for your help