Skip to main content

2 Messages

 • 

80 Points

Sat, Nov 21, 2015 8:50 AM

0

Unleashed to Standalone R600 fails

Reflash from R600 Unleashed to Standalone fails. After 45 minutes on the chat/phone with support, they provided article on how to reflash from Unleashed to StandAlone R600. Everything went well and I've got a message that the firmware was flashed successfully but 2 of the units are not responding at all - steady green light, hard reset goes from Red to Green immediately only power light is on, nothing else. Any hint/ideas will be greatly appreciated. Quite frustrating experience...
Thanks,
Michael Abadjiev

Responses

Brand User

Former Employee

 • 

2.6K Messages

 • 

44.8K Points

5 years ago

Factory Default the AP after changing firmware.

2 Messages

 • 

80 Points

5 years ago

Do you mean push the pinhole for 10 seconds? I did this more than a dozen times. It boots and the power light changes from Red to Green - that's all. I RMA the units however.