Skip to main content

5 Messages

 • 

150 Points

Thu, Aug 27, 2020 12:53 AM

Answered

Ruckus R700 converted to standalone mode and now DIR light is blinking

I installed the standalone firmware on a R700 AP that was running the Zone Director firmware. Now the DIR light on the AP is blinking green. 

How would I stop the DR light from flashing with the standalone firmware installed? 

Responses

232 Messages

 • 

4K Points

3 months ago

Is http or https up? if so you may be able to "turn off LEDs" in the GUI.

5 Messages

 • 

150 Points

3 months ago

Yes.. I am able to access the web interface for the AP. However, I don't see any settings to turn off the DIR blinking light.

Employee

 • 

604 Messages

 • 

10K Points

Hi PG,

I don't think in standalone mode there is an option to disable LED. It is only available when AP is managed by controller.

Below is the AP's DIR LED behavior.
  • Off: The AP is not being managed by a controller (Standalone mode)
  • Green: The AP is being managed by a controller
  • Slow flashing green (one flash every two seconds): The AP is managed by a controller but is currently unable to communicate with it.
  • Fast flashing green (two flashes every second): The AP is managed by a controller and is currently receiving configuration settings or an image update.
Make sure there is no controller IP set on APs configuration.

Run below command to check if controller IP is configured.

get director

or 

get scg

If you find an IP is configured, please delete it by running below command.

get director ip del
reboot

or

set scg ip del

Regards,
Syamantak Omer

Regards,

Syamantak Omer

5 Messages

 • 

150 Points

3 months ago


Here are the results I getting after I SSH into the AP. There is no controller IP specified. The AP is running in Stand-alone mode. 

So, I'm not sure why I'm getting the slow flashing green light on the DIR led.


Employee

 • 

604 Messages

 • 

10K Points

Please run below command and check the status after reboot.

set scg disable
reboot

Also provide the output of below command.

get version

Regards,
Syamantak Omer

Regards,

Syamantak Omer

5 Messages

 • 

150 Points

3 months ago

That worked. The DIR led light is off now.

The Standalone firmware version I'm running is 110.0.0.0.675.

Employee

 • 

604 Messages

 • 

10K Points

Great!

"scg service" was enabled means AP was capable of finding a v/SZ/Cloud controller and that is why control traffic was generated and that is what DIR LED was indicating.

Regards,
Syamantak Omer

Regards,

Syamantak Omer