Skip to main content

1 Message

 • 

70 Points

Fri, May 6, 2016 12:01 AM

Answered

Passthrough on LAN2 port for R710 ?

I am trying to use LAN2 to supply wired access to a another device i.e a switch or workstation/printer

This is possible with other brand APs, does it not work with ruckus?

In a few scenerios you can do something like

Main Bldg Mesh AP-----------------Remote Bldg Mesh AP->Switch (or device)

Only time I was able to get link out of LAN2 port was while it was booting, i've tried a straight cable as well as a crossover cable

Responses

37 Messages

 • 

592 Points

4 years ago

Configure LAN2 with Access VLAN or Trunk

4 Messages

 • 

120 Points

4 years ago

Did you ever get this to work? I have tried all settings for LAN 2 and cannot get a link. Running 9.12.2.0.101

Champion

 • 

556 Messages

 • 

10.5K Points

4 years ago

Definitely works on my R710 without any settings changes. Possibly a dumb question: Do you have a PoE+ switch and is the AP recognizing it as such (e.g. get power-mode says 802.3AT)?

Without AT mode, the 2nd LAN port is disabled.

4 Messages

 • 

120 Points

4 years ago

That makes sense, thanks for the reply! It would have taken me awhile to think of that. I will try it with a poe+ switch.

9 Messages

 • 

130 Points

4 years ago

Does the LAN2 Port work in DC mode? I am using a 12V 2A AC adapter, but cannot enable the LAN2 port.