Skip to main content

Mon, Feb 25, 2019 4:36 AM

Initial R720 setup Cant Connect https http or ssh

I'm configuring an R720, going through the initial setup. I factory reset the device and I can ping the default IP 192.168.0.1, however I cannot access it via the web or through SSH. There's a strong possibility that this device was once configured with a ZoneDirector, I've read that might be the problem. I'm new to Rukus and I just want to know if there's anything I can do in this situation without going through ZoneDirector, which I've never used before.

Responses

5 Messages

 • 

120 Points

2 years ago

Hi Adi,

if you set your AP to factory default you can SSH into it via default username and password. i.e. super and sp-admin.
if it not set to factory default. you can SSH into it via username and password you configured for in zone configuration for AP management
for http / https access you have to enable it after SSH into to the AP.

rkscli: set http
Usage:
        set http {enable|disable}

        set https {enable|disable}

Hope it will fix your issue.
Ta,
Babar

2 Messages

 • 

90 Points

2 years ago

Hi Babar, 

Thank you answer, but I reset the factory default by pressing the reset button 10 seconds, but to ping 192.168.0.1 is ok.
whereas I try to ssh it can't


Thank You

Adi

13 Messages

 • 

190 Points


Friend good morning, Could you solve the problem? What should I do? thank you

13 Messages

 • 

190 Points


Friend good morning, Could you solve the problem? It turns out that I have the same situation that you mention and I would like to know if you could find a solution. thank you

14 Messages

 • 

260 Points

2 years ago

Hi Adi,

How your R720 connected to your network? might be, there's an IP duplication. To make sure connect your AP and your computer to PoE injector only. Try to open network folder too on your PC or use Wireshark. if you still having a problem open a ticket to ruckus support portal. 

PS
Try to hard reset your AP again for 20sec. hope will work :)