Skip to main content

8 Messages


170 Points

Fri, Jan 3, 2020 7:42 AM


Im tryng to setup unleaead Network and it is asking the password. I'm putting the Last 6 of MAC address and filing


43 Messages


1K Points

10 months ago

If AP's Configure-Me-xx:yy:zz(last 3 octets of AP's eth mac) is asking for a password(Preshared key), may be it is not running Unleashed firmware (200.x series). It is running Standalone/Controller firmware (10x series).

Use the serial number of the Access point as preshared key for WLAN connectivity. super and sp-admin are username password for GUI access.