Skip to main content

allen_chen_ctg2spdvqxi63

5 Messages

•

104 Points

Sun, Sep 30, 2018 5:03 AM

How to turn-off island-XXXXXX SSID ?

R510 used as closure network wifi service. I had already created my own SSID, but there is still a SSID Island-XXXX broadcasting. very very annoying! Please help~

Responses

1said_sanoussi

31 Messages

•

610 Points

2 years ago

You Island SSID is broadcasting because you have a mesh configured. The AP can't find its controller and trherefore broadcasting the Island SSID. can not be turned off. Unless you factory default the controller and configure the network wihtout mesh

0

1said_sanoussi

31 Messages

•

610 Points

2 years ago

You can however create a new AP group without mesh as a workarround. MAybe that's an option for you

6

allen_chen_ctg2spdvqxi63

5 Messages

•

104 Points

thank you for your reply. Is there any method to turn-off the mesh function directly? and how should I create a new AP group without mesh as a workarround? Could you please share the steps with me? thank you very much~~~

Like

2 years ago

0

1said_sanoussi

31 Messages

•

610 Points

Are you running a Zonedirector 1100,1200, 3000 or a SZ?

Like

2 years ago

allen_chen_ctg2spdvqxi63

5 Messages

•

104 Points

No, I don't use any Zonedirector device. It's just a standalone AP connecting with our ordinary router and server. thank you

Like

2 years ago

0

1said_sanoussi

31 Messages

•

610 Points

In that case it is strange. I think you have an AP that was once connected to a controller with mesh configured on it. You have to factory default the AP by holding the reset button for 8 - 10sec that will remove your config including the mesh settings. Yuo can then just configure your AP as standalone.

Like

2 years ago

dan_nguyenphuc

2 Messages

•

90 Points

Interestingly enough, my R720 started advertising Island-XXXXXX SSID after I did the factory-default reset by holding down reset button...

Like

2 years ago

allen_chen_ctg2spdvqxi63

5 Messages

•

104 Points

2 years ago

thank you for your reply. Is there any method to turn-off the mesh function directly? and how should I create a new AP group without mesh as a workarround? Could you please share the steps with me? thank you very much~~~

0

0