Skip to main content

48 Messages


884 Points

Fri, Jul 10, 2015 2:42 AM


Any reason not to enable 802.11r/k

We have a lot of iOS clients on our wlans and I'm wanting to know if there is any reason NOT to enable 802.11r and k on these wlans? (we have ZD1100 running 9.9.1) Is there any downside or negative effect I'm not aware of? I'm always wary of settings that are defaulted to off... makes me wonder if there's a reason you wouldn't want to enable them.


824 Messages


13.2K Points

5 years ago

Hi jim

802.11r/k is primarily for seamless roaming and if you WiFi network is working ok including roaming for all type of devices including ioS then its ok to have it off

however if i would be in your place then i would enable it as all devices do NOT support and those do support will have better and quick roaming experience.

apple device by the way support 802.11r/k so better to have it ON...

read -

Hope this helps in making better decision...

2 Messages


80 Points

5 years ago

From personal experience we have a large ruckus deployment and 802.11r isn't ready for prime time.  We run a 802.1x network and with 802.11r IoS devices couldn't connect after the radius authentication hand shake.  When we turned off 802.11r the devices could connect again.  If your network is working fine then leave it off.

4 Messages


124 Points

5 years ago

I am using the zero IT activation and have r/k enabled seems to work fine for most devices, however we have had a few 7-8 year old laptops that will not connect once the r/k was turned on. We where having issues with devices moving from AP to AP when mobile, with turning on the r/k that has improved that issue. 



556 Messages


10.5K Points

5 years ago

Certain extremely old pieces of hardware (especially 802.11b/g devices) refuse to connect or even recognize networks that have 802.11r enabled. I got burned by this after digging up some PC relics to salvage some data off of them.

But they are few and far in between. If you are concerned about this, you may want to make a separate "legacy" SSID for such devices.

6 Messages


112 Points

5 years ago

just clone the wlan and have the same ssid, havent had any issues when doing this.    some olderish macbooks wont connect with it on, almost every device 2 years or newer will support 11k/r.

155 Messages


2.7K Points

a year ago

Even so it is an old question, I want to post correction.
Actually situation isn't that good -- still mainly just mobile devices support k/r (Android, Ios from v.6.). Windows PCs and laptops support 802.11k/r only in W10 and only for Radius Authentication. W7/W8 doesn't support 11k/r, and W10 doesn't support it with WPA2/PSK. 
Windows devices can (and will) have issues (starting from packet loss to disconnects or inability to connect) -- that mainly depends on which WLAN card and driver are used.
So if network is used mainly for Windows PCs without Radius authentication - there is no reason to enable it, as it will not  work anyway and may create issues.
Some older Intel adapters with W7 even show misleading message "wrong key", when try to connect to WPA2/PSK network with k/r enabled.
Hope it helps -- I had many cases when customers enabled k/r and had difficult to diagnose issues, and disabling k/r fixed things.