icx6450 8030n not showing up (show version) and not upgrading properly
Upgrading ICX6450 to replace a faulty ICX6450 in client's environment.
The faulty device uses ICX64R08030n.bin firmware.
When We attempt to flash the replacement ICX6450 the version shows an incorrect firmware version: SW: Version 08.0.10mT311
Also, we need to be able to ip route this switch. I do not see references to be able to do this in command reference guides for 8030n. I want to ensure we are able to perform this configuration change so we can move forward.
Is there any reason why when we upload the firmware onto the flash it does not commit to the desired version?
I have tried erasing the flash, re-uploading the files, booting to secondary, and we are still getting the same results.
Please let me know if you would like additional information
Show Version Information:
System initialization completed...console going online.
Copyright (c) 1996-2014 Brocade Communications Systems, Inc. All rights reserved.
UNIT 1: compiled on Jul 8 2015 at 15:39:10 labeled as ICX64S08010m
(8119232 bytes) from Primary ICX64R08030n.bin
SW: Version 08.0.10mT311
Boot-Monitor Image size = 786944, Version:10.1.05T310 (kxz10105)
HW: Stackable ICX6450-48-HPOE
UNIT 1: SL 1: ICX6450-48p POE 48-port Management Module
Serial #: BZT0443J077
License: BASE_SOFT_PACKAGE (LID: dbvFJJIlFMM)
P-ENGINE 0: type DEF0, rev 01
P-ENGINE 1: type DEF0, rev 01
UNIT 1: SL 2: ICX6450-SFP-Plus 4port 40G Module
800 MHz ARM processor ARMv5TE, 400 MHz bus
65536 KB flash memory
512 MB DRAM
STACKID 1 system uptime is 27 seconds
The system : started=warm start reloaded=by "reload"