Skip to main content

Mon, Feb 22, 2016 8:33 AM

Need information for the scenario.

Hello everyone,friends please help me out, my scenario is we have zd controller and we have 2 new access points we need to place in different subnets under one zd for using fail over concept will it be possible ,please explain the scenario.Thanks in advance.

Responses

62 Messages

 • 

936 Points

5 years ago

What do you mean by two different subnets.  As long as they can reach the ZD through the internet, one is not dependent on the other.  If you are looking for true redundancy, you should look into running redundant ZD's since if the ZD goes down, both APs will go down as well.

3 Messages

 • 

90 Points

5 years ago

Thanks Alan for the reply,what i mean is 1 AP in 1 subnet another AP in another subnet ,these two subnets are differ by distance of kilometers.Could you please explain the "running redundant zd's".
Thankyou very much Alan.

62 Messages

 • 

936 Points

5 years ago

Both APs will be on different internet circuits so they will have local IP addresses.  The APs report into the ZD controller and if the AP is in controller managed mode, when it loses communication with the ZD, the APs will stop broadcasting the SSID since it has no way to manage itself.  If you have two ZD's they can be connected together.  In case one ZD fails, the APs report automatically to the 2nd ZD.  And both ZD's automatically stay in synch and licensing is only needed for 1 of the ZD's.

3 Messages

 • 

90 Points

5 years ago

Hi Alan,please reply this post.I have two zone directors(ZD) for example "ABC" location we have ZD1 and XYZ location we have ZD2 and these two ZD's are in different subnets and in different locations, these are connected through WAN link,we assume ZD1 is primary and ZD2 is secondary, for some reasons wan was disconnected until the wan connection comes up will both ZD's can act as primary ZD's for their respective access points is my question,and will this scenario in real time workout? Thanks in advance.

62 Messages

 • 

936 Points

5 years ago

The ZD's do not necessarily have to be at the locations to manage the APs.  They just need to be reachable over the WAN.  Both ZD's would need to be on the subnet and then set to Smart Redundancy Mode so they sync with each other. Only one ZD will actively manage the APs and the 2nd ZD will be in standby mode.  There are other ways of setting up the redundancy as well.  You can use the different subnets for the ZD's as long as they see each other but it is not recommeneded.  Refer to the ZD manual and search for smart redundancy.