Skip to main content

Wed, May 24, 2017 7:09 AM

can't add R700 to ZD3000

Hello, i have new AP R700 & ZD 3000
FW  9.7.0.0 build 220, i know what i can't add this, because fw is to old. Needed 9.8 fw and above. Where i can take a new fw for connect ap to controller ?

Responses

65 Messages

 • 

1.1K Points

4 years ago

Hi i will give you further a googledrive link to download it...let me just time to add to my drive

7 Messages

 • 

200 Points

4 years ago

okey thank you!

65 Messages

 • 

1.1K Points

You will need to upgrade step by step (from older to most newer version) until the version of firmware you need.
I prepare a ''we transfer'' link so will have it soon

7 Messages

 • 

200 Points

4 years ago

Thank you i downloaded it and upgrade to 9.8.0.0.373 R700 added to controller
but after upgrade i see this
Your Support service expires in [90] days. Upgrading your Support service entitles you to future firmware upgrades. Please contact Ruckus Support for further assistance. [What's this?]
What happens after 90 days ?

65 Messages

 • 

1.1K Points

4 years ago

Hi this message is only for support license ,if you don't need this don't worry ,personnaly this message appear on my ZD since 2years ,and i can use it without problem ;)

7 Messages

 • 

200 Points

4 years ago

thank you for help!

65 Messages

 • 

1.1K Points

4 years ago

You're welcome guy

22 Messages

 • 

352 Points

4 years ago

Hello I have a zd1200 and an access point t301s, and I can not add the access point on the controller, although I ping is well between the ap and the controller, the access point is new and updating On the controller is 9.12

65 Messages

 • 

1.1K Points

4 years ago

Hi
How many AP did you have already on this ZD?
What about your AP licence,hiw many AP licence did yiu have?

65 Messages

 • 

1.1K Points

4 years ago

How many availlable licence?

22 Messages

 • 

352 Points

4 years ago

his is not a licensing problem because I have a license of 36 ap, and I have only 35 ap connected

22 Messages

 • 

352 Points

4 years ago

i acced to the ap by ssh and I notice that the command "set director ip"  does not exist, it existe only the commande ''set scg ip"

16 Messages

 • 

244 Points

"set scg ip" means that use firmware Smartzone/vSZ.
Reset your ap t301 and go to 192.168.0.1. change to firmware standalone t301s. try again ssh "set director ip" 

22 Messages

 • 

352 Points

please how can i change to firmware standalone t301s, i try to download the firmwares but No firmware was running

16 Messages

 • 

244 Points

You can download the firmware standalone (100.1) 839-standalone-ap-software-100-1-0-0-432-outdoor-aps
please follow my step before

16 Messages

 • 

244 Points

1. Reset the AP : you can see the reset button on the side of port AP
2. Go to 192.168.0.1 and upgrade to standalone firmware

22 Messages

 • 

352 Points

I am far from the site now if you can give me your email to contact you when I will be on site, i think i already download this firmware but the ap Does not accept any firmware