vSZ - Configure new AP

Hello Roberto,
the easiest way is to connect to your APs and enter the vSZ IP address :
- In CLI : (login with username and password indicate on the stickers behind your AP)
enter : "set scg ip your_sz_ip_address"
then you can check the connection via "get scg"

- In HTTPS : (same login / password as above)
go in "Administration > Management"
Put "Set Controller Address (Reboot to take effect)" to enable.
Enter the vSZ IP address in "Primary Controller Addr:" field.
(same as CLI, you can ping the vSZ from "Administration > Diagnostics")

In both case, AP will reboot and you will find it in the "Staging Zone" of your vSZ.

If you have a lot of APs to do, it's better to redirect them via DHCP option 43. (your AP get autonatically vSZ IP when connecting)

Thanks for support Martin, AP are not shipped yet.
When I have it (5 units), I will follow your CLI suggestion.

Regards,
Leandro