Skip to main content

1 Message


72 Points

Fri, Nov 8, 2019 6:02 AM

SZ 100 - CLI - Access Point Description - No space

I have 600 Access Points to configure on Smartzone 100 v3.

It is easier to configure via CLI with the below commands:

description Living_Room

Similarly to web interface AP description configiuration, I would like to omit the underscore and keep a space between the two words in description:

Expected output →  "Living Room"
Due to error on CLI, output is "Living_Room"

How to configure this "description: Living_Room" without the " _ " in SZ cli.

Awaiting your prompt replies. Thank you


No Responses!