configuring ipv6 in unleashed-cli not working

Sorry Beni,

   While many Unleashed commands come from ZoneDirector, not all commands/features from ZD are supported in Unleashed.

For example, from the latest Unleashed 200.7 User Guide:
https://support.ruckuswireless.com/documents/2599-ruckus-unleashed-200-7-ga-user-guide


Unleashed Limitations and Deviations from ZoneDirector

While many ZoneDirector features are included, Unleashed does not provide the entire ZoneDirector feature set.
The following features are either not supported, supported but with limitations, or are currently unsupported but planned for a future release:

• No layer 3 roaming. All APs must be in the same subnet.

• Tunneled WLANs are not supported.

• IPv6 is not supported.

• No interface to communicate with SmartCell Insight, SPoT, or the ZoneDirector Remote Control mobile app.

• No North Bound Interface to pass client authentication responsibility to an external entity.

• No WLAN Groups.

IPv6 is not supported.

That's going to be an increasingly significant limitation.  Is it on the roadmap?

Dear Michael,

Thanks for your response. My question came up because the command is documented in the current 200.7 CLI reference guide here:
https://support.ruckuswireless.com/do...

So I have two guesses about this particular command:
- a copy-paste mishap from a ZD documentation
- the implementation of the command is around the corner and documentation overtook the software,

Kind regards

Same documentation typo in 200.8.

no worries. Someone asked why ipv6 is important 2 years ago. Because no one should suffer through windows ipv6to ipv4 tunnel adapter (teredo)

Observation:

I was a bit dejected to learn that Unleashed doesn't work with IPv6, but in fact, I find that with 200.8.10.3.278, it "mostly" works. As long as I do not activate client isolation on a WLAN, clients on the WLAN work fine with IPv6. Even if assigned to a VLAN.  Of course, the management UI / ssh are also IPv4 only as are any L3 ACLs.

This is without activating any command through the CLI.  I am guessing this is because the packets are just passed along at L2, so the AP is blind to IPv4 vs IPv6.

Is IPV6 now support on unleashed products (R610)?

Reason i ask is i cannot see any settings anywhere in any of the menus, although i do appear to have IPV6 addresses on devices.