Skip to main content

16 Messages

 • 

280 Points

Mon, Nov 18, 2019 9:38 PM

Answered

configuring ipv6 in unleashed-cli not working

The cli documentation says that in config-ap mode one can enable ipv6 with 200.7 unleashed firmware. (
I have a R510 (200.7.10.202.92) and ipv6 is no recognized command. According to the cli guide, the command would be
"ipv6 enable mode auto"

Is anyone able to reproduce this?

Responses

Brand User

Former Employee

 • 

2.6K Messages

 • 

44.8K Points

a year ago

Sorry Beni,

   While many Unleashed commands come from ZoneDirector, not all commands/features from ZD are supported in Unleashed.

For example, from the latest Unleashed 200.7 User Guide:
https://support.ruckuswireless.com/documents/2599-ruckus-unleashed-200-7-ga-user-guide


Unleashed Limitations and Deviations from ZoneDirector

While many ZoneDirector features are included, Unleashed does not provide the entire ZoneDirector feature set.
The following features are either not supported, supported but with limitations, or are currently unsupported but planned for a future release:

• No layer 3 roaming. All APs must be in the same subnet.

• Tunneled WLANs are not supported.

• IPv6 is not supported.

• No interface to communicate with SmartCell Insight, SPoT, or the ZoneDirector Remote Control mobile app.

• No North Bound Interface to pass client authentication responsibility to an external entity.

• No WLAN Groups.

1 Message

 • 

60 Points

a year ago

IPv6 is not supported.
That's going to be an increasingly significant limitation.  Is it on the roadmap?


16 Messages

 • 

280 Points

a year ago

Dear Michael,

Thanks for your response. My question came up because the command is documented in the current 200.7 CLI reference guide here:
https://support.ruckuswireless.com/do...

So I have two guesses about this particular command:
- a copy-paste mishap from a ZD documentation
- the implementation of the command is around the corner and documentation overtook the software,

Kind regards
Brand User

Former Employee

 • 

2.6K Messages

 • 

44.8K Points

Thanks, I think you are right!

3 Messages

 • 

82 Points

5 months ago

Same documentation typo in 200.8.

3 Messages

 • 

82 Points

5 months ago

no worries. Someone asked why ipv6 is important 2 years ago. Because no one should suffer through windows ipv6to ipv4 tunnel adapter (teredo)

13 Messages

 • 

192 Points

4 months ago

Observation:

I was a bit dejected to learn that Unleashed doesn't work with IPv6, but in fact, I find that with 200.8.10.3.278, it "mostly" works. As long as I do not activate client isolation on a WLAN, clients on the WLAN work fine with IPv6. Even if assigned to a VLAN.  Of course, the management UI / ssh are also IPv4 only as are any L3 ACLs.

This is without activating any command through the CLI.  I am guessing this is because the packets are just passed along at L2, so the AP is blind to IPv4 vs IPv6.

93 Messages

 • 

1.3K Points

2 months ago

Is IPV6 now support on unleashed products (R610)?

Reason i ask is i cannot see any settings anywhere in any of the menus, although i do appear to have IPV6 addresses on devices.

Official Rep

 • 

97 Messages

 • 

1.6K Points